FIAT Panda User Manual

Page 31

The head restraint may move when the backrest is
pressed by the occupant's torso or hand: this
behaviour is caused by the system and should not be
considered a malfunction.

WARNING

All adjustments must be made with the
car stationary. Head restraints must

be adjusted so that the head, rather than the
neck, rests on them. Only when they are
adjusted in this manner can they serve their
intended purpose.

WARNING

To make the best use of the head
restraint's protective action, adjust the

backrest so that you are sitting upright and
keep your head as close as possible to the head
restraint.

REAR
(for versions/markets, where provided)

Depending on the version, the rear seats may be
fitted with two or three height-adjustable head
restraints.
Upwards adjustment: raise the head restraint
until it clicks into place.

Downwards adjustment: press button A fig. 20
and lower the head restraint.
Proceed as follows to remove the head restraints:
❒ raise the head restraints to their maximum height;
❒ press buttons A and B fig. 20 at the side of the

two supports, then remove the head restraints
by pulling them upwards.

IMPORTANT If the rear seats are used, always set
the head restraints in the "completely raised"
position.

fig. 20

F0W0201

GETTING TO

KNOW YOUR CAR

SAFETY

STARTING AND

DRIVING

WARNING LIGHTS

AND MESSAGES

IN AN EMERGENCY

SERVICING AND

MAINTENANCE

TECHNICAL

SPECIFICATIONS

INDEX