FIAT Panda - Manual (Page 151)

❒ fit handle D fig. 114 into the housing in device A,
operate the jack and raise the car until the wheel
is a few centimetres from the ground;
❒ remove the wheel cap after loosening the 3 fixing
bolts and finally loosen the fourth bolt and extract
the wheel (only for versions with wheel caps
fixed by bolts);
❒ make sure the contact surfaces between
space-saver wheel and hub are clean so that the
fastening bolts will not come loose;
❒ fit the space-saver wheel by inserting the first bolt
for two threads into the hole closest to the valve;
❒ take the wrench A fig. 113 and fully tighten the
fixing bolts;
❒ operate the jack handle D to lower the car. Then
extract the jack;
❒ use the wrench A provided to fully tighten the
bolts in a criss-cross fashion as per the numerical
sequence illustrated in fig. 116;
❒ when replacing an alloy wheel it is advisable to
place it upside down, with the aesthetic part facing
upwards.
fig. 113 F0W0179
fig. 114 F0W0025
fig. 115 F0W0024
147
GETTINGTO KNOW
YOURCAR
SAFETY
STARTING AND
DRIVING
WARNING LIGHTS
AND MESSAGES
IN AN
EMERGENCY
SERVICING AND
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX