FIAT Panda - Manual (Page 198)

Replacing the wiper blades
Proceed as follows:
❒ raise the wiper arm, press tab A fig. 155 of the
attachment spring and remove the blade from
the arm;
❒ fit the new blade, inserting the tab into the special
slot in the arm, making sure that it is locked;
❒ lower the windscreen wiper arm on the
windscreen.
Do not operate the windscreen wiper with
the blades lifted from the windscreen.
Replacing the rear window wiper blade
Proceed as follows:
❒ raise cover A fig. 156, undo nut B and remove arm
C;
❒ correctly position the new arm, fully tighten nut B
then lower cover A.
SPRAY NOZZLES
Windscreen washer
The windscreen washer jets A fig. 157 can be
adjusted rotating the side notch with a screwdriver
B. If there is no jet of fluid, firstly check that there is
fluid in the reservoir (see "Checking fluid levels" in
this chapter).
Then check that the nozzle holes are not clogged;
use a needle to unblock them if necessary.
fig. 155 F0W0186 fig. 156 F0W0222
194
GETTINGTO KNOW
YOURCAR
SAFETY
STARTING AND
DRIVING
WARNING LIGHTS
AND MESSAGES
IN AN EMERGENCY
SERVICING AND
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX