FIAT Panda User Manual

Page 20

TRIP COMPUTER

General information

The Trip computer is used to display information on
car operation when the key is turned to MAR-ON.
Two separate trips, called “Trip A” and “Trip B”,
are provided to monitor the entire mission (journey)
in a reciprocally independent manner.
Both functions can be reset (reset - start of a new
journey).
“Trip A” is used to display the figures relating to:
❒ Outside temperature (for versions/markets where

provided)

❒ Range
❒ Distance covered
❒ Average consumption
❒ Instantaneous consumption
❒ Average speed
❒ Trip time (driving time).
“Trip B” is used to display the figures relating to:
❒ Distance travelled B
❒ Average consumption B
❒ Average speed B
❒ Trip time B (driving time).

Note The “Trip B” function may be disabled (see
“Activating Trip B”). The “Range” and “Instant
consumption" parameters cannot be reset.

Values displayed

Range

This indicates the approximate distance which can be
travelled with the amount of fuel present in the
tank. “- - - -” will appear on the display in the
following cases:
❒ range value lower than 50 km (or 30 mi)
❒ car parked with engine running for an extended

period.

IMPORTANT The range value variation can be
affected by several factors: driving style, type of route
(motorway, urban, mountain roads, etc.), conditions
of use (load, tyre pressures, etc.). Trip planning
must therefore take the above into account.

Distance covered

Shows the distance covered since the start of the
new journey.

Average consumption

Shows the approximate average fuel consumption
since the start of the new journey.

Instantaneous consumption

This indicates the fuel consumption. The value is
constantly updated. The display will show “- - - -” if
the car is parked with the engine running.

GETTING TO

KNOW YOUR CAR

SAFETY

STARTING AND

DRIVING

WARNING LIGHTS

AND MESSAGES

IN AN EMERGENCY

SERVICING AND

MAINTENANCE

TECHNICAL

SPECIFICATIONS

INDEX