M-AUDIO DMAN - Manual (Page 46)

46
specified in the "WssDmaPlay=" line of the [PNP] section.
Possible settings are 0,1,3.
NOTE : Sound Blaster and WSS share the same interrupt and
playback DMA channel. Therefore, a conflict error with SB
will also affect WSS configuration settings.
CODEC Port Address: If the CODEC test fails, you may have a
port address conflict. Change the I/O Port Address that the
application is using to communicate with the sound card by
changing the "WssIO=" line in the CS4232.INI file. Set it to 534,
608, E84 or F44.
CODEC Interrupt: If the CODEC test fails, you may have an
interrupt (IRQ) conflict. Change the interrupt setting used to
communicate with your sound card. The interrupt is set by the
line "WssInt=" in the CS4232.INI file. Set it to 5,7,9,11,12 or 15.
CODEC DMA Channel Conflict: If the CODEC test fails, you
may have a DMA capture or playback channel conflict. Change
the DMA Capture or Playback Channel settings in the CS4232.INI
file, which are specified in the "WssDmaCapture=" and
"WssDmaPlay=" lines of the [PNP] section. Possible settings are
0,1 and 3. Set both to the same value for half-duplex operation
and to different values for full-duplex.
MPU401 Port Address: If the MPU401 test fails, you may have a
port address conflict. Change the I/O Port Address that the
application is using to communicate with DMAN by changing the
"MPU401IO=" line in the CS4232.INI file. Set it to 300, 320, 332,
338, 340 or 360. This value may have to be adjusted to match the
acceptable values in the Windows 3.1x MPU401 driver.
MPU401 Interrupt: If the MPU401 test fails, you may have an
interrupt (IRQ) conflict. Change the interrupt setting used to
communicate with the MPU401 port. The interrupt is set by the
line "MPU401Int=" in the CS4232.INI file. Set it to 5,7,9 or 11.