M-AUDIO DMAN - Manual (Page 32)

32
5. While installing the Windows 95 drivers, the installer
program also modifies your AUTOEXEC.BAT and
CONFIG.SYS files. It inserts the board initialization utility
CS4232C.EXE in CONFIG.SYS and also adds a CS32MIX.EXE
call to AUTOEXEC.BAT, which initializes the DMAN audio
mixer on bootup.
6. After completion of the driver installation, if your system has
no PnP or PnP is disabled, Windows 95 will require you to
restart Windows 95. If it does request a restart, remove the
floppy disk from drive A: and respond “yes.” The system
will restart and your DMAN is ready for play!
7. If PnP is enabled and installation completes without any
conflicts, the DMAN is ready for immediate use.
Windows 95 Driver Configuration
Windows 95 displays the DMAN driver status in the Device
Manager page of the System Properties dialog box. The Systems
Properties dialog is opened via the Windows 95 Start button.
Select ‘Settings, Control Panel’ to open the Windows 95 Control
Panel. Then select ‘System’ from the Control Panel to open the
System Properties dialog. Below is an example view of the
Device Manager device list.
System Properties - Device Manager