Xerox 721P88200 - Manual (Page 86)

INCORPORATING XEROX VALUE-ADDED FEATURES
5-18 DOCUPRINT IPS SOLUTIONS GUIDE
DFA is supported on the DocuPrint 180 IPS, 4635 IPS, 96 MICR IPS,
4635 MICR IPS, 180 MICR, and 4890 IPS. Currently, DFA is not
supported for the DocuPrint 4050 IPS, 4090 IPS, and 4850 IPS. This
table provides additional notes for the DocuPrint IPS printers that
support DFA functionality:
Note: Note that the following functions are not supported by any
DocuPrint IPS printers:
• automatic restart of the printer after clearing a “full” condition of
the finishing device
•
the LCDS (Xerox data stream) equivalent of Segment
Management.
Contact your Xerox Account Representative to determine which
third-party feeding and finishing devices are supported for your
DocuPrint IPS printing system.
Table 5-2. DFA support for DocuPrint IPS
DocuPrint
IPS Additional notes
180 and 180
MICR
If a Roll Systems roll-to-cut sheet feeder is attached, no
input enablement kit is required. However, you can
attach the feeder to the back of the feeder/stacker
modules. This replaces the feeder in that module. The
stacker is still functional.
If a bypass transport is attached, you can have a
maximum of three feeder/stacker modules only.
Set Recovery and Sheet Recovery are supported.
4635 and
4635 MICR
If a roll-to-cut sheet feeder is attached, you must also
have an Input Enablement Kit. Also, you can have
maximum of three feeder/stacker modules only.
If a bypass transport is attached, you can have a
maximum of three feeder/stacker modules only.
Set Recovery and Sheet Recovery are supported.
4890 If a roll-to-cut sheet feeder is attached, paper tray 2 is
used. Also, an Input Enablement Kit is not required.
Set Recovery and Sheet Recovery are not supported.