Xantrex Technology PROwatt 1000 - Manual (Page 8)

Important Safety Information
viii
locations that require ignition-protected equipment. These locations
include any space containing gasoline-powered machinery, fuel
tanks, as well as joints, fittings, or other connections between
components of the fuel system.
Precautions When Working With Batteries
1. Follow all instructions published by the battery manufacturer and
the manufacturer of the equipment in which the battery is installed.
2. Make sure the area around the battery is well ventilated.
3. Never smoke or allow a spark or flame near the engine or batteries.
4. Use caution to reduce the risk of dropping a metal tool on the
battery. It could spark or short circuit the battery or other electrical
parts and could cause an explosion.
5. Remove metal items like rings, bracelets, and watches when
working with lead-acid batteries. Lead-acid batteries produce a
short-circuit current high enough to weld a ring or the like to metal,
and thus cause a severe burn.
6. If you need to remove a battery, always remove the positive
terminal from the battery first. Make sure all accessories are off so
you don’t cause an arc.
Precautions For Using Rechargeable Appliances
Most battery-operated equipment uses a separate charger or transformer
that is plugged into an AC receptacle and produces a low voltage output.
If the label on the AC adapter or charger states that the adapter or
charger produces a low voltage AC or DC output (less than 30 volts),
the Prowatt 1000 can power this charger or adapter safely.
Some chargers for small nickel-cadmium batteries can be damaged if
connected to the Prowatt 1000. Do not use the following with the
Prowatt 1000:
• Small battery-operated appliances like flashlights, razors, and night
lights that can be plugged directly into an AC receptacle to recharge
• Chargers for battery packs used in hand power tools. These chargers
display a warning label stating that dangerous voltages are present
at the battery terminals.
PROWatt100.book Page viii Friday, January 5, 2001 3:03 PM