Xantrex Technology PROwatt 1000 - Manual (Page 27)

Choosing a Location
3–5
Choosing a Location
The Prowatt 1000 must only be installed in a location that is:
WARNING
The PROwatt 1000 contains components that tend to produce
arcs or sparks. To prevent fire or explosion, do not install the
inverter in compartments containing batteries or flammable
materials or in locations that require ignition-protected
equipment.
WARNING
To reduce the risk of fire, do not cover or obstruct the
ventilation openings. Do not install the PROwatt 1000 in a zero-
clearance compartment. Overheating may result.
Dry Do not allow water or other liquids to drop or splash on the
inverter.
Cool Ambient air temperature should be between 32º F and
105º F (0º C and 40º C)—the cooler the better within this
range.
Ventilated Allow at least 2 inches (5 cm) of clearance around the
inverter for air flow. Ensure that ventilation openings on the
DC end and the bottom of the unit are not obstructed.
Safe Do not install the inverter in the same compartment as
batteries or in any compartment capable of storing
flammable liquids like gasoline.
Close to
battery Do not use excessive DC cable lengths: they increase wire
resistance and reduce input power. Longer AC wires are
preferable to longer DC wires: wire resistance (and
therefore voltage drop) is less and the cost is lower.
Protected
from battery
gases Do not mount the inverter where it will be exposed to gases
produced by the batteries. These gases are very corrosive,
and prolonged exposure will damage the inverter.
PROWatt100.book Page 5 Friday, January 5, 2001 3:03 PM