Zoom ADSL X3 - Manual (Page 41)

Chapter 3: Advanced Setup Options 41
Resetting Default Settings
If you have changed the system settings on your X3 and for some
reason want to restore them to the factory default settings, you can
do so in one of two ways: You can perform a software reset or a
hard reset.
To reset using the X3’s Web interface
If you can open your Web browser and access your X3’s user
interface, do the following to perform a software reset:
1111
Log into the Zoom Configuration Manager and click the
Advanced Setup icon to open the Advanced Setup page.
(See page 15 if you need help logging in.)
2222
In the Administration section, click the Reboot button.
3333
From the Reboot Mode drop-down list, select Reboot From
Default Configuration.
4444
Click the Reboot button. Once this process is complete, your
unit is reset to its factory settings.
To perform a hard reset
If you lose your link to the unit and cannot communicate with it
via the Web browser, do the following to perform a hard reset:
1111
Insert a paper clip into the RESET pinhole in the center of
the modem’s back panel.
2222
Hold it there for five seconds. The unit’s LINK light will turn
off and then it will blink slowly, about once per second.
You are now guaranteed that all system settings are restored to the
X3’s factory defaults.