Xerox 5550 - Manual (Page 97)

Printing on Specialty Media
Phaser® 5550 Printer
4-36
2. Insert the transparencies long-edge feed into Tray 1 (MPT) or Tray 6.
Note: Do not load paper above the fill line inside the tray.
3. Adjust the paper guides to the size of the transparencies if necessary.
4. If prompted on the control panel, press the OK button to accept the paper size and type
that are shown. If you have changed the paper size or type, do the following:
a. Select Change setup , and then press the OK button.
b. Select Transparency , and then press the OK button.
c. Select the paper size, and then press the OK button to save your selection.
5. In the printer driver, select either Transparency as the paper type or the tray you loaded as
the paper source.
Printing Transparencies from Trays 2-5
1. Fan the transparencies to release sheets that may stick together.
Tray 1 (MPT) Long-Edge Feed Tray 6 Long-Edge Feed
5550-142
MAX
5550-118
5550-170