Xerox 5550 - Manual (Page 54)

UNIX (Linux)
Phaser® 5550 Printer
3-24
UNIX (Linux)
Your printer supports connection to a variety of UNIX platforms through the parallel and
network interface. The workstations currently supported by CentreWare for UNIX/Linux to a
network-connected printer are:
■ Sun Solaris
■ IBM AIX
■ Hewlett-Packard HP-UX
■ Linux (i386)
■ Linux (PPC)
The following procedures enable you to connect your printer using any of the supported
versions of UNIX or Linux listed above.
Quick Install Steps
Perform the following procedures to set up the printer and install the appropriate drivers.
From the Printer
To set up the printer:
1. Verify that both TCP/IP protocol and the proper connector are enabled.
2. On the control panel, select one of these IP address options:
■ Allow the printer to set up a DHCP address.
■ Enter the IP address manually.
3. Print the Configuration page and keep it for reference.