Zoom 4420-A - Manual (Page 7)

Chapter 1. Installing the AP+4 7
Connecting the Hardware
1111
Put the AP+4 near a computer to be used for setup. That
computer needs an Ethernet (LAN) port.
2222
Turn off the computer.
3333
Connect one end of the supplied power cube to the AP+4
PWR jack, and the other end to a live power source.
Important! Only use the power cube shipped with the
AP+4. Other power cubes may damage the device.
The PWR LED on the AP+4 front panel should turn on and
the WLAN LED should flash. (The WLAN LED continues to
flash to signify broadcast activity as long as the Wireless
LAN is enabled. It is enabled by default.)
4444
Connect one end of the supplied Ethernet cable to the
computer’s Ethernet port and the other end to one of the
AP+4’s LAN ports.
5555
Turn on the computer.
The WLAN LED continues flashing and the connected LAN
port and the ACT (Activity) LEDs become steady on. (If you
have a 10 Mbps Ethernet connection, the LAN LED does not
turn on.)
6666
If you want the AP+4 to have access to the Internet, connect
its WAN port to the Ethernet port on your cable modem,
ADSL modem, or other broadband device.
The WAN LED turns on.