Zoom 4420-A - Manual (Page 33)

Chapter 5. TCP/IP Settings 33
DHCP Client
Range The default range is shown: 10.0.0.1 to
10.0.0.199. Enter a different range if desired.
Click Show Clients to view a list of connected
devices.
Domain Name If you have a large network that uses domains,
enter a name.
802. 1d Spanning
Tree
If the AP+4 is operating as a bridge, select
Enable
to use this protocol, which limits the
chances of network failure.
Clone MAC
Address (Optional) Enter the MAC address of one of the
devices in the network, which will be sent to
the Internet Service Provider instead of the
AP+4’s address.
Click Apply Changes to save your entries or Reset to return to
the defaults.
Important: After you make changes, you must reboot all
devices attached to the AP+4.