Xantrex Technology XW POWER SYSTEM XW4024-120/240-60 - Manual (Page 29)

Step 1: Installing the Mounting Plate
975-0239-01-01 2–5
Figure 2-3 Mounting the Bracket for the XW Inverter/Charger or Distribution Panel
Wall studs 16" on center behind
wallboard
Add ¾" plywood if additional support is
needed.
Side View
2 × 4 wall stud
Wallboard
Plywood
(optional)
mounting plate
60" (152.4 cm) from floor
puts the inverter display
panel at approx. 65"
high.
Multiple mounting plates should fit together
as shown.
1 Locate the wall studs.
If necessary, enhance the support surface with a ¾" plywood panel
secured to the wall studs. Plywood should span at least three wall studs.
Use hardware sized to support a minimum of 500 lbs (not provided) to
secure the plywood to the wall.
Using a level, secure the first mounting bracket to the wall. Use
recommended anchoring hardware to secure the plate (see Table 2-1).
Mount the next bracket adjacent to the first one. The brackets are designed
to interlock, so additional mounting brackets are easily installed without
additional measuring or levelling.
2
3
4
5