Yamaha RX-V3800 - Manual (Page 78)

74
En
Graphical user interface (GUI) screen
Use this feature to select the sound field programs (see
page 45), the surround decode mode or the “STRAIGHT”
mode (see page 50), and adjust the parameters of each
program.
■ Selecting sound field programs and
setting the parameters by using GUI
screen
1
Set the operation mode selector to D
AMP
and then press G
SET MENU.
2
Press 4k / n / l / h repeatedly to select
“Stereo/Surround” and then press 4h.
3
Press 4k / n repeatedly to select the desired
category of the programs and then press
4h.
4
Press 4k / n repeatedly to select the desired
programs.
5
Press 4h on the remote control and then
4k / n to select the desired parameter.
y
You can select “Initialize” to set all the parameters of the
selected sound field program to the default values. See
page 80 for details.
6
Press 4h and then press 4l / h to adjust
the selected parameter.
7
Press 4
ENTER or 4k / n to confirm the
setting of the selected parameter.
■ Basic configuration of sound field
programs
Each sound field program has some parameters defining
the characteristics of the program. To customize the
selected sound field program, adjust “DSP Level” and/or
“Dialogue Lift” first, and then try other parameters.
Adjusting the effect sound level of the sound
field programs (DSP Level)
Sound field programs add effect sounds (DSP effect
sounds) to the original source sound to create sound field
in the listening room. Use the “DSP Level” parameter to
adjust the level of the effect sounds.
Adjust “DSP Level” as follows:
Increase the value of “DSP Level” when
• the effect sound of the selected sound field
program is too weak.
• you cannot recognize any difference between the
sound field programs.
Decrease the value of “DSP Level” when
• the sound is vague.
• you feel that the additional sound effect is
excessive.
Control range: – 6 dB to +3 dB
Stereo/Surround
(Stereo/Surround menu)
The DSP effect
sound level is low.
The DSP effect sound
level is high.