Yamaha RX-V3800 - Manual (Page 129)

125
En
Advanced setup
AD
V
ANCED
OPERA
T
ION
English
■ Remote control XM ID RC XM ID
(U.S.A. and Canada models only)
Use this feature to set the XM ID of this unit for remote
control recognition.
Choices: ID1, ID2
• Select “ID1” when the remote control XM ID library
code is set to “2604”.
• Select “ID2” when the remote control XM ID library
code is set to “2605”.
Setting remote control XM ID
1
Set the operation mode selector to D
AMP or
D SOURCE and then press 1XM on the
remote control to select the XM to change the
remote control ID.
2
Press and hold M
LEARN for about 3
seconds using a ballpoint pen or similar
object until “L;TUN” and “XM” alternately
appear in the display window (B) on the
remote control.
• Be sure to press and hold MLEARN for at least 3
seconds, otherwise the learning process will start.
• If you do not complete each of the following steps within
30 seconds, the setting mode will be automatically
canceled. In this case, start over from step 2.
3
Press 4
ENTER.
The four-digit code set for the selected input area
appears in the display window (B) on the remote
control.
4
Press the numeric buttons (6) to enter the
four-digit remote control code for the input
area you want to use.
*1 The remote control setting.
*2 The setting of this unit.
5
Press 4
ENTER to set the number.
“OK” appears in the display window (B) if the
setting was successful.
“NG” appears in the display window (B) if the
setting was unsuccessful. In this case, start over from
step 2.
6
Press M
LEARN again to exit from the setup
mode.
Notes
LEARN
3 seconds
Remote
control XM
ID code *1
Function RC XM ID *2
2604
(initial setting)
Operates this unit using the
default code. ID1
(initial setting)
2605
Operates this unit using an
alternative code.
ID2
See page 122 for the operation of the advanced setup.
LEARN