Yamaha RX-V3800 - Manual (Page 124)

120
En
Using multi-zone configuration
■ Adjusting the volume level of Zone 2 or
Zone 3
Rotate R
VOLUME on the front panel (or press
C
VOLUME +/–) to adjust the volume level of the
selected zone.
y
Press EMUTE on the remote control to mute the sound output to
the selected zone.
When you use the external amplifiers in Zone 2 or Zone 3,
CVOLUME +/– can be used only when “Zone2 Volume” or
“Zone3 Volume” is set to “Variable” in “Zone2 Set” or “Zone3
Set” (see page 97).
■ Adjusting the balance of the speaker
level in Zone 2 or Zone 3
Press E
TONE CONTROL repeatedly to select
“BALANCE” and then rotate O
PROGRAM to
adjust the balance of the front left and right
speaker level of the selected zone.
■ Adjusting the tonal quality of Zone 2 or
Zone 3
Set the operation mode selector to D
AMP and
then press
CH +/– on the remote control to
adjust the high-frequency response (TREBLE) or
TV VOL +/– to adjust the low-frequency
response (BASS) respectively.
y
You can also adjust the tonal quality of Zone 2 or Zone 3 by using
ETONE CONTROL on the front panel. For details, see
“Adjusting the tonal quality” on page 51.
Check that “ZONE 2” or “ZONE 3” is displayed in the display
window (B) of the remote control before you adjust the tonal
quality of the corresponding zone (see page 119).
■ Using Zone 2/Zone 3 remote control
You can control Zone 2 or Zone 3 features by using the
supplied Zone 2/Zone 3 remote control. First, set the ID1/
ID2 switch and ZONE 2/ZONE 3 switch appropriately.
Controlling the amplifier function
1 XM
Selects XM as the input source of the controlling zone.
2 Input selector buttons
Selects the desired input source for the controlling zone.
8 ID1/ID2 switch
Switches the remote control ID between ID1 and ID2 (see
page 124).
0 POWER
Turns on Zone 2 or Zone 3.
This button is operational only when AMASTER ON/OFF on
the front panel is pressed inward to the ON position.
A STANDBY
Sets Zone 2 or Zone 3 to the standby mode.
This button is operational only when AMASTER ON/OFF on
the front panel is pressed inward to the ON position.
Operate the following operations after activating the Zone 2
or Zone 3 operation mode.
Note
Note
–
+
TV VOL
+
–
CH
TV
SOURCE
AMP
TREBLE
BASS
Note
Note
TUNER CD CD-R
MD/TAPE DVD BD/HD DVD NET/USB
DTV/CBL VCR V-AUX/DOCK DVR
POWER XM
STANDBY
A-E/CAT.
PRESET/CH
A/B/C/D/E
PRESET VOLUME
ZONE 3 ZONE 2 ID2 ID1
NUMBER
CAT. ALL PRESET
DISPLAY
MUTE
1 2 3
4 5
ENT
6
7 8 9 0
8
9
G
D
E
F
C
B
A
0
2
3
4
6
7
5
1