Figure 34 internet connection (pppoe), Table 15 internet connection – ZyXEL Communications P-660H-Tx v2 User Manual
Page 73

Chapter 5 WAN Setup
P-660H-Tx v2 User’s Guide
73
Figure 34 Internet Connection (PPPoE)
The following table describes the labels in this screen.
Table 15 Internet Connection
LABEL
DESCRIPTION
General
Name
Enter the name of your Internet Service Provider, e.g., MyISP. This information
is for identification purposes only.
Mode
Select Routing (default) from the drop-down list box if your ISP allows multiple
computers to share an Internet account. Otherwise select Bridge.
Encapsulation
Select the method of encapsulation used by your ISP from the drop-down list
box. Choices vary depending on the mode you select in the Mode field.
If you select Bridge in the Mode field, select either PPPoA or RFC 1483.
If you select Routing in the Mode field, select PPPoA, RFC 1483, ENET
ENCAP or PPPoE.
User Name
(PPPoA and PPPoE encapsulation only) Enter the user name exactly as your
ISP assigned. If assigned a name in the form user@domain where domain
identifies a service name, then enter both components exactly as given.
Password
(PPPoA and PPPoE encapsulation only) Enter the password associated with the
user name above.
Service Name
(PPPoE only) Type the name of your PPPoE service here.
Multiplexing
Select the method of multiplexing used by your ISP from the drop-down list.
Choices are VC or LLC.