ZyXEL Communications P-660H-Tx v2 - Manual (Page 238)

Appendix A Product Specifications
P-660H-Tx v2 User’s Guide
238
1
Be careful to avoid damaging pipes or cables located inside the wall when
drilling holes for the screws.
2 Do not insert the screws all the way into the wall. Leave a small gap of about 0.5 cm
between the heads of the screws and the wall.
3 Make sure the screws are snugly fastened to the wall. They need to hold the weight of
the ZyXEL Device with the connection cables.
4 Align the holes on the back of the ZyXEL Device with the screws on the wall. Hang the
ZyXEL Device on the screws.
Figure 127 Wall-mounting Example
The following are dimensions of an M4 tap screw and masonry plug used for wall mounting.
All measurements are in millimeters (mm).
Figure 128 Masonry Plug and M4 Tap Screw