Figure 52 – ZyXEL Communications HomePlug AV DMA-1100P User Manual
Page 84
Chapter 12 The ENCRYPT Button
DMA-1100P User’s Guide
84
Figure 52 ENCRYPT Connection Procedure
5 Repeat step
in this section for the other powerline device you wish to connect. This
must be done within 120 seconds of pressing the ENCRYPT button on the DMA.Wait
for about one minute while your powerline devices connect.
V
If the HomePlug (
) lights on both powerline devices do not light up, the
powerline devices are not connected. Repeat steps 4 and 5 in this section. If
that doesn’t work, see Section 13.3 on page 91 for suggestions.
6 To add more powerline devices to your network, press the ENCRYPT button on device
C (shown below) for more than 10 seconds until the HomePlug (
) turns off.
7 Then repeat steps
and
in this section using any powerline device (A or B) you have
connected using ENCRYPT and the powerline device you want to connect (C). You
must use the ENCRYPT button on both devices.
Figure 53 Adding More Powerline Adapters to Your Network
8 If you disconnected your computer or modem (or any other networking product
connected to your powerline device) in step
of this section, you can now reconnect
them.
This sets up your powerline network between your powerline devices.
press 2 seconds
press 2 seconds
within 2
minutes
A
B
OR
C
A
B