Xerox X2 - Manual (Page 26)

160g/m 2 Banner Fabric 15
Description
Tear resistant, free-flowing polyester fabric designed for optimum image quality in either 360 or 720
dpi print mode, for use indoors or outdoors against a flat surface without lamination. A functional
fabric that can be "finished" to become a vast array of graphics. It has a satin sheen on the backside.
Applications
Ideal for indoor and outdoor banner applications, hanging banners, table fronts, backdrops, window
decorations, ceiling displays, drapes or flags: Trade shows, art galleries, retail and event
promotions, entrance lobbies and corridors, showrooms, supermarkets, shopping centres,
restaurants, ceiling displays, museums, sport arenas, political campaigns …
Physical Characteristics
Base Weight 160 g/m 2
Total Calliper 250 microns
Durability
Tensile strength
Tearing resistance >1500 n/5cm warp, >1400 n/5cm weft
>70 N warp, >70N weft
Indoor Unlaminated 2 years
Outdoor Unlaminated 1 year
<0.5%
Temperature stability
Dimensional stability -10deg C to +60 deg C
Dimensions
Code Length
023R01415 54” 1372mm 25m
023R01414 42" 1067mm 25m
023R01416 36” 914mm 25m
Width
Compatibility
Xerox X2
Xerox Xpress
Seiko IP4XXX
Operating Instructions
• Store in a cool, dry environment, free from direct sunlight, within temperatures of 10-35 o C and
non-condensing relative humidity of 30-70%. Store the product in its original carton and
wrapper to protect from dust and moisture. Shelf life is 2 years if kept in original packaging.
• Ensure that roll ends are protected and that the edges of the media are not damaged. If the
media edges are not flat this can result in damage to the printer.
• Keep the image surface dry and free of grease, oil, silicones and dirt.
• Use within the temperature range 18-30˚C and relative humidity of 40-60%.
• Fabric is coated over a textured, porous surface. The coating layer on the peaks of the weave
may develop a tendency to "rub-off" if over saturated with ink such as in areas of CMY / CMYK
black. Working at lower ink limits improves image weather resistance.
• An automatic cutter should not be used during media loading or print production.
• Can be handled normally immediately after printing. Use cotton gloves to minimise image rub-
off during installation. Only a small amount of moisture from hands can increase rub-off.
• Do not fold images. Use "slip sheets" to prevent image offset from one print to another.
• Can be stitched with care. Avoid "bunching-up" when sewing. Grommets can be used.
• Over-lamination is not required.
• Outdoors this product should be fixed to a flat structure e.g. building wall. If hung without
protection wind may cause the coating surface to crack, leading to image deterioration.
www.xerox.com/iccprofiles.com
26