Xerox X2 - Manual (Page 21)

236g/m 2 Reinforced Paper 10
Description
A nylon reinforced paper designed for producing vivid, full colour images in 360 dpi mode. The
exceptional durability of this media provides maximum flexibility during post print handling allowing
for edge sewing, taping and grommeting. It provides excellent laminate adhesion with pressure
sensitive as well as thermal laminates. It is an economical paper alternative to using standard
outdoor materials for indoor banner applications.
NOTE: For use with both Thermal and Pressure Sensitive overlaminates. Must be overlaminated on
both sides of a print for long term outdoor use (more than 3 days exposure).
Applications
Excellent for all large format, indoor banner applications including retail, car showrooms,
supermarkets, suspended ceiling displays, office parties, museums, art galleries, entranceways,
office corridors, industrial signage (warnings, hazard, etc.) - vertical or horizontal.
As a laminated paper, this media can be utilised for all presentation applications like trade show
backdrops, mounted prints, window posters, suspended ceiling displays, exhibition graphics,
shopping centre displays and retail signage.
Physical Characteristics
Base Weight 236 g/m 2 Indoor Laminated 10 years
Calliper 280 microns Indoor Unlaminated 1 year
Opacity 97% Outdoor Laminated 2 years
Brightness 104 Outdoor Unlaminated 2 days
Durability
Dimensions
Code Length
023R01296 54” 1372mm 23m
023R01293 36” 914mm 23m
Width
Compatibility
Xerox X2
Xerox Xpress
Seiko IP4XXX
Operating Instructions
• Store in a cool, dry environment, free from direct sunlight, within temperatures of 10-35 o C and non-
condensing relative humidity of 30-70%. Store the product in its original carton and wrapper to protect
from dust and moisture. Shelf life is 2 years if kept in original packaging.
• Ensure that roll ends are protected and that the edges of the media are not damaged. If the media edges
are not flat this can result in damage to the printer.
• Keep the image surface dry and free of grease, oil, silicones and dirt. It is recommended that cotton gloves
be used for handling to avoid fingerprints.
• Use within the temperature range 18-30˚C and relative humidity of 40-60%.
• For use in 360 dpi print mode only.
• This material is suitable for standard finishing procedures for banners: Edges can be sewn and the banner
can be punched for eyelets. To form large displays, panels should be overlapped 2-3 cm and seamed. A
double stitched hem with a maximum of 5 stitches per inch is recommended.
• Laminate with either pressure or thermal laminates if prints are to be exposed to severe conditions, or if
longer durability is required. Heavier weight thermal laminates work best on this paper. Use at least a 125
micron laminate to avoid showing an “orange peel” effect.
www.xerox.com/iccprofiles.com
21