Xerox 4112 - Manual (Page 18)

18
Environmental Requirements
Environmental Factor Recommended Minimum Maximum
Temperature 70 degrees F (22
Celsius) 50 degrees F
(10 Celsius) 90 degrees F
(32 Celsius)
Humidity 45% RH 15% RH 80% RH
Altitude (above sea level) 0 feet (0 m) 10,000 feet
(3,048 M)
Power Consumption (approximate)
Energy Star (eStar) compliant. See
Power Requirements for more
information Standby: 375w
Low Power:
120w
Sleep Mode:
13w Running:
1.92Kw
Noise (Approximate sound pressure
level at operator position) Standby (dbA)
54.4
Running (dbA)
78.7
Peak (dbA) 81.5
Nominal Voltage 208 VAC 187VAC 254VAC
Heat Output Standby:
1500 BTU/Hr 50/60 Hz run is
7680 BTU/Hr
NOTE 1: If above 90 Degrees F (32 Celsius), reduced relative humidity is required to maintain the
specific performance.
NOTE 2: For altitudes above 10,000 feet, equipment shutdown rates may increase.
Electrical Requirements
The electrical outlet must be located within 6 feet (1828 mm) to the right of the right rear corner of
the main processor, or no more than 3 feet (914 mm) to the left of the left rear corner of the main
processor (when facing the machine). The outlet/circuit cannot be shared with any other devices
or equipment.
Printer System (Western Hemisphere)
Main
Processor Optional
Controller
All Feeders and Finishers
(each require a separate electrical
connection)
Nominal
Voltage 208-240 VAC
(+6% to -10%)
100-240 VAC,
single phase (+6%
to -10%)
100-240 VAC, single phase (+6% to
-10%)
Amperage 15 3 15
Cycles 50/60 HZ 50/60 HZ 50/60 HZ
Receptacle
NEMA Part No.
6-15R 5-15R
5-15R
Xerox
Receptacle Part
No. 600S3704 600S3704
Power Cord
Length 8.2 feet/2.5
meters
6 feet/3 meters
10 feet/3 meters
Receptacle
Diagram (North
America only:
All others:
Flying-leads)
Power 150 W maximum 60 W maximum
Compliance:
North America : Energy Star (eStar), Choice, cULus,
Europe: CE, NEMKO, WEEE compliance