Zebra S4M - Manual (Page 100)

Troubleshooting
Communications Problems 94
13290L-001 Rev. A S4M User Guide 10/21/05
Communications Problems
Table 18 identifies problems with communications, the possible causes, and the recommended
solutions.
Table 18 • Communications Problems
Problem Possible Cause Recommended Solution
A label format was sent to
the printer but was not
recognized. The communication
parameters are incorrect. Check the printer driver or software
communications settings (if applicable).
Make sure you are using the correct
communication cable. See
Data Cable
Requirements on page 24 for the requirements.
If a driver is used, check the driver
communication settings for your connection.
A label format was sent to
the printer. Several labels
print, then the printer
skips, misplaces, misses, or
distorts the image on the
label. The serial communication
settings are incorrect. Ensure that the flow control settings match.
Check the communication cable length. See
Data Cable Requirements on page 24 for
requirements.
Check the printer driver or software
communications settings (if applicable).
A label format was sent to
the printer but was not
recognized. No printing
occurs. The prefix and delimiter
characters set in the printer
do not match the ones in the
label format. Verify the prefix and delimiter characters. See
Set Command Character on page 68 and Set
Delimiter Character on page 68 for the
requirements.
Incorrect data is being sent
to the printer. Ensure that the label format being used
matches the operating language of the printer.
See
Printer Language Modes on page 14 .
Check the communication settings on the
computer. Ensure that they match the printer
settings.
If the problem continues, check the label
format.