Zebra S4M User Manual
Page 80
Configuration
Control Panel LCD Display
74
13290L-001 Rev. A
S4M User Guide
10/21/05
ZebraNet
®
Wired and Wireless Print Server LCD Displays
display only if you have the ZebraNet PrintServer II, or
10/100 PrintServer, or Wireless Print Server installed and are operating in ZPL or EPL mode.
These parameters are considered part of Level 3.
Table 12 • Print Server LCD Displays (Page 1 of 2)
Parameter
Explanation
OBTAIN IP ADDRESS
Obtain an IP Address
Selects the method by which an IP address will be assigned to the printer.
Selections: AUTO SELECT (dynamic), PERMANENT (user-specified)
Default Value: AUTO SELECT
To modify this parameter:
• Press the up or down arrow to scroll through the selections.
CHANGE IP ADDRESS
Change the Printer’s IP Address
This parameter can be modified only when
PERMANENT
is selected for
OBTAIN IP ADDRESS
.
Selections: 0 to 255 for each field
Default Value: 0.0.0.0
Note •
Leading zeroes are not shown in the address. If an IP
address contains more digits than can be displayed at one time, use
the left or right arrows to scroll through the digits.
To modify this parameter:
• To increase the value, press the up arrow.
• To decrease the value, press the down arrow.
CHANGE SUBNET
Change the Subnet
This parameter can be modified only when
PERMANENT
is selected for
OBTAIN IP ADDRESS
.
Selections: 0 to 255 for each field
Default Value: 0.0.0.0
Note •
Leading zeroes are not shown in the address. If an IP
address contains more digits than can be displayed at one time, use
the left or right arrows to scroll through the digits.
To modify this parameter:
• To increase the value, press the up arrow.
• To decrease the value, press the down arrow.