Zebra S4M User Manual
Page 73
67
Configuration
Control Panel LCD Display
10/21/05
S4M User Guide
13290L-001 Rev. A
STATUS RESPONSE
(APL-I mode only)
Send APL-I Status Response
Determines if a response is sent after inquiry commands. The format is set
with the
RESPONSE FORMAT
parameter.
Selections: ON, OFF
Default Value: ON
To modify this parameter:
• Press the up or down arrow to scroll through the selections.
RESPONSE FORMAT
(APL-I mode only)
Select APL-I Response Format
If
STATUS RESPONSE
is set to
ON
, this parameter determines the
format of the response.
Selections: ASCII, BINARY
Default Value: ASCII
To modify this parameter:
• Press the up or down arrow to scroll through the selections.
PARITY
Set Parity
The parity of the printer must match the parity of the host computer for
accurate communications to take place. Select the parity that matches the
one being used by the host computer.
Selections: NONE, ODD, EVEN
Default Value: NONE
To modify this parameter:
• Press the up or down arrow to scroll through the selections.
HOST HANDSHAKE
Set Host Handshake
The handshake protocol of the printer must match the handshake protocol
of the host computer for proper communications to take place. Select the
handshake protocol that matches the one being used by the host computer.
Selections (ZPL, APL-D): XON/XOFF, DSR/DTR, RTS/CTS
Selections (EPL): DTR & XON/XOF, DTR, XON/XOFF
Selections (APL-I): XON/XOFF, DSR/DTR, RTS/CTS, APL-I
Default Value: XON/XOFF
To modify this parameter:
• Press the up or down arrow to scroll through the selections.
Table 11 • Printer Parameters, Level 3 (Page 3 of 9)
Parameter
Explanation