Zebra S4M - Manual (Page 96)

Troubleshooting
Print Quality Problems 90
13290L-001 Rev. A S4M User Guide 10/21/05
Print Quality Problems
Table 16 identifies problems with print quality, the possible causes, and the recommended
solutions.
Table 16 • Print Quality Problems
Problem Possible Cause Recommended Solution
General print quality
issues The printer is set at the
incorrect print speed. For optimal print quality, set the print speed to
the lowest possible setting for your application
via control panel, the driver, or the software. See
Adjust Print Speed on page 63 . You may wish to
perform the FEED Self Test on page 100 .
You are using an incorrect
combination of labels and
ribbon for your application. Consult your authorized Zebra reseller or
distributor for information and advice.
The printer is set at an incorrect
darkness level. For optimal print quality, set the darkness to the
lowest possible setting for your application via
the control panel, the driver, or the software. See
Adjust Print Darkness on page 60 . You may wish
to perform the FEED Self Test on page 100 to
determine the ideal darkness setting.
The printhead is dirty. Clean the printhead according to the instructions
in
Clean the Printhead and Platen Roller
on page 79 .
Caution • The printhead may be hot
enough to cause severe burns. Allow
the printhead to cool.
Caution • Observe proper electrostatic
safety precautions when handling any
static-sensitive components such as
circuit boards and printheads.