Zebra Technologies S-300 - Manual (Page 43)

Media Sensor Position Adjustment
This procedure was covered in Chapter 1. See page 10.
Ribbon Supply Spindle Adjustment
This procedure was covered in Chapter 1. See page 11.
Backing Rewind Power Roller Adjustment (Peel-Off Option Required)
NOTE: This Roller is only present on printers with the Peel-Off Option. Zebra presets this
Roller during manufacture for proper operation with most applications. Only adjust this
Roller when necessary.
In the Peel-Off Mode, proper media tracking is critical. The Rewind Power Roller
automatically turns along with the movement of media, to insure continuous rewind of
the label backing material. When adjusting this roller, the operating position may vary
due to the type, width, and thickness of the backing material.
Before performing this adjustment, review the Media Loading procedure in Chapter 1.
Insure minimal sideways movement during the printing process by positioning the left
edge of the label backing even with the Edge Guide Mark on the Tear-Off/Peel-Off
Plate. Position the outer Media Guides against the outside edge of the media, but not so
tight as to bind the material.
Figure 26 Backing Rewind Power Roller
3
Rout ine Car e and Adjustment
35