Zebra Technologies S-300 - Manual (Page 35)

Cleaning the Cutter Module (For Printers Equipped with the Optional Cutter)
The Cutter Module requires periodic cleaning to remove paper dust and gummed label
residue. The procedure on the following pages should be performed by the operator
according to the schedule on page 25. However, depending on your application and
media type you may need to clean the cutter more or less frequently.
NOTE: In the figures shown, media and ribbon have been removed for clarity. It is not
necessary to remove media or ribbon before performing the maintenance procedures de-
scribed.
IMPORTANT: Do not exchange Cutter Modules between different printers. The Cutter
Module adjustments are optimized during installation to work with a particular printer and
may not perform correctly if the module is placed on a different printer.
Figure 17 Cutter Module and Catch Tray Location
3
Rout ine Car e and Adjustment
27