Zebra Technologies S-300 - Manual (Page 11)

Voltage Selection
The Stripe is available from the factory preset for either 100-120 VAC electrical power
or 220-240 VAC electrical power. Refer to the product label on the back of the
printer and make sure that the unit is properly configured for your power
requirements.
AC Power Cable
The AC Power Cable has a three-prong female connector on one end. See Figure 2. This
connector must be plugged into the mating connector on the left side of the printer. See
Figure 1.
The electrical connection at the other end of the AC Power Cable will be one of the
following:
•
US Standard 110 VAC three-prong plug
•
Great Britain Standard 220 VAC three-prong plug
•
European Standard 220 VAC three-prong plug
WARNING!! For personnel and equipment safety, always use a three-prong
plug with an earth ground connection.
Insure that the AC Power ON/OFF Switch is in the OFF (0) position before connecting
the AC Power Cable to a nearby electrical outlet.
Figure 1 Cable Connections
Figure 2 AC Power Cable
1
Get ting Star ted
3