Zebra Technologies S-300 - Manual (Page 12)

Communications
The Stripe comes with either an Electronics Industries Association (EIA) RS-232 serial
data interface or a factory-installed parallel interface. In both cases, you must supply
the required interface cable for your application. See the Appendix for specific cable
requirements.
CAUTION: Zebra printers comply with FCC “ Rules and Regulations” , Part 15, Subpart
J, for Class A Equipment, using fully shielded six-foot data cables. Use of longer cables
or unshielded cables may increase radiated emissions above the Class A limits.
Cutter Module Interface (For Stripes with the Factory-Installed Cutter Option)
The Cutter Module connects to the printer via a standard 8-pin connector.
The cable on the front of the printer plugs into the connector on the bottom of the Cutter
Module once the Cutter Module has been installed.
Get ting Star ted
4