Zebra Technologies S-300 - Manual (Page 2)

Proprietary Statement
This manual contains proprietary information of Zebra Technologies Corporation. It is
intended solely for the information and use of parties operating and maintaining the
equipment described herein. Such proprietary information may not be used, reproduced, or
disclosed to any other parties for any other purpose without the expressed written permis-
sion of Zebra Technologies Corporation.
Product Improvements
Continuous improvement of products is a policy of Zebra Technologies Corporation. All
specifications and signs are subject to change without notice.
FCC Compliance Statement
Note: This equipment has been tested and found to comply with the limits for a Class A
digital Device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference when the equipment is operated in a
commercial environment. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions manual, may cause
harmful interference to radio communications. Operation of this equipment in a residential
area is likely to cause harmful interference in which case the user will be required to correct
the interference at his own expense.
In order to insure compliance, this printer must be used with a Shielded Power Cord and
Shielded Communication Cables.
“ The user is cautioned that any changes or modifications not expressly approved by Zebra
Technologies Corporation could void the user’s authority to operate the equipment.”
Canadian DOC Compliance Statement
This digital apparatus does not exceed the Class A limits for radio noise emissions from
digital apparatus as set out in the radio interference regulations of the Canadian Department
of Communications.
Liability Disclaimer
Zebra Technologies Corporation takes steps to assure that its published Engineering specifica-
tions and Manuals are correct; however, errors do occur. Zebra Technologies Corporation has
been advised of the possibility of such damages. Because some states do not allow the exclusion
or limitation of liability for consequential or incidental damages, the above limitation may not
apply to you.
Copyrights
This copyrighted manual and the label printer described herein are owned by Zebra
Technologies Corporation. All rights are reserved. Unauthorized reproduction of this man-
ual or the software in the label printer may result in imprisonment of up to one year and
fines of up to $10,000 (17 U.S.C.506). Copyright violators may be subject to civil liability.
Centronics

is a registered trademark of Genicom Corporation
IBM

is a registered trademark of IBM Corporation
Zebra
®
, Stripe
®
, ZPL
®
, and ZPL II
®
are registered trademarks of Zebra Technologies
Corporation
© Zebra Technologies Corporation