ZyXEL Communications Omni 288S User Manual
Page 68
Chapter 9 - Fax Operation
9-6
Command
Value
Description
+FDR
Receive phase C data command; initiates
document reception.
+FDT=df,vr,wd, ln
Transmit phase C data command: release the
DCE to proceed with negotiation.
+FECM=n
Error mode control:
n=0
Error mode is disabled.
n=2
Error correcting mode is enabled, handled by
the DCE alone, including buffering of partial
pages.
+FET=n
End of page or document command:
n=0
More pages; same document.
n=1
End of document; another document follows.
n=2
No more pages or documents.
n=4
Procedure interrupt; another page follows.
n=5
Procedure interrupt; end of document, another
document follows.
n=6
Procedure interrupt; end of document.
+FK
Regular fax abort command.
+FLID="string"
Local ID string parameter.
+FLO=n
Flow control options:
n=0
No flow control.
n=1
Set XON/XOFF software flow control.
n=2
Set CTS/RTS hardware flow control.
+FLPL=n
Document for polling command:
n=0
The DTE has no document available for
polling.
n=1
Indicate a document available for polling.
+FMDL?
Request DCE model .
+FMFR?
Request DCE manufacturer .
+FMINSP=n
Minimum phase C speed parameter:
n=0
2400 bps.
n=1
4800 bps.
n=2
7200 bps.
n=3
9600 bps.
n=4
12000 bps.
n=5
14400 bps.
+FPHCTO=
0-255
DTE Phase C response timeout:
Determine how long the DCE will wait for a
command after reaching the end of data when
transmitting in Phase C.
+FPTS=n
Page transfer status