ZyXEL Communications Omni 288S User Manual
Page 100
Chapter 11 - AT Command Set Summaries
11-2
Command
Options
Function & Description
Ref.
M2
Speaker always ON
M3
Speaker ON after the last digit is dialed out and OFF
when carrier is detected
Nn
n=0-7
5 *
Ring volume control.'N0' will disable the audio ring
function
S24.1-3
O
Return to on-line state
O1
Force modem to request a retrain
Qn
Result code displayed
S23.7
Q0 *
Modem returns result code
Q1
Modem does not return result code
Q2
Modem returns result code but quiet after answering on a
RING (see also S42.2)
S40.1
Sr.b=n
Set bit 'b' of S-register 'r' to value 'n'. 'n' is a binary digit
'0' or '1'
Sr.b?
Display value of bit 'b' of S-register 'r'
Sr=n
Set S-register 'r' to value 'n'. 'n' must be a decimal
number between 0 and 255
Sr?
Display value stored in S-register 'r'
T
Ton dial
S23.1
UPX
Download firmware to the Flash EPROM usin Xmodem
protocol
Vn
Sets display type for Result Codes
S23.6
V0
Display result code in numeric form. (See also S35.7 and
the result code table of 'ATXn')
V1 *
Display result code in verbose form.
Xn
n=0-7
5 *
Result code options, see the Options Table
S23.3-5
Zn
n=0-4
Reset modem and set power-on profile.
S15.5-7
Zn
Reset modem and load user profile n (0-3).
Z4
Reset modem and load factory settings.
$
Basic command summary help