ZyXEL Communications Omni 288S - Manual (Page 24)

Chapter 2 - Installation
2-9
If the User name and Password are incorrect or missing, type them in. Click on the
Connect button and your Omni 288S will dial the number and establish a
connection to your Internet Service Provider.
Note: The default protocol for Dial-up Networking is Point-to-Point
Protocol (PPP). If your ISP requires you to use Serial Line
Interface Protocol (SLIP), you may need to create a special
logon script file. Because the procedures for logging on with
SLIP accounts vary greatly from ISP to ISP, you should consult
the technical support department of your service provider for
this information.
Setup for DOS Fax/Modem Software
After installing the Omni 288S, use the following procedures to verify your
modem connections.
1. Install and load your communications software. If you need assistance, refer
to the manual that came with the software.
2. If your communications software requires you to select a modem, and the
ZyXEL Omni 288S is not one of the choices, you can either check our web
site for the driver or select the ZyXEL U-1496 modem. In many cases, the
commands for these modems are identical.