ZyXEL Communications Omni 288S User Manual
Page 67
Chapter 9 - Fax Operation
9-5
Command
Value
Description
+FCTCRTY=
0-255
ECM retry count; in Error Mode only:
The sender will try to send a partial page 4
times.
the Continue To Correct (CTC) count is 0, it
will not make any further attempts.
+FDCC=vr,br,wd,ln,
df,ec,bf,st
DCE capabilities parameters.
vr=0
Vertical resolution: Normal; 98 lpi.
vr=1
Vertical resolution: Fine; 196 lpi.
br=0
Bit rate: 2400 bit/s; V.27ter.
br=1
Bit rate: 4800 bit/s; V.27ter.
br=2
Bit rate: 7200 bit/s; V.29 or V.17.
br=3
Bit rate: 9600 bit/s; V.29 or V.17.
br=4
Bit rate: 12000 bit/s; V.17.
br=5
Bit rate: 14400 bit/s; V.17.
wd=0
Page width: 1728 pixels in 215mm.
wd=1
Page width: 2048 pixels in 255mm.
wd=2
Page width: 2432 pixels in 303mm.
ln=0
Page length: A4; 297mm.
ln=1
Page length: B4; 364mm.
ln=2
Page length: unlimited length.
df=0
Data compression format: 1-D; modified
Huffman.
df=1
Data compression format: 2-D; modified
Read.
ec=0
Error correction disabled.
ec=1
Enable error correction mode.
bf=0
Disable binary file transfer.
st=0
Minimum scan time/line: 0 ms.
st=1
Minimum scan time/line: 5 ms.
st=2
Minimum scan time/line:10 ms (normal);
5 ms (fine).
st=3
Minimum scan time/line:10 ms.
st=4
Minimum scan time/line:20 ms (normal);
10ms (fine).
st=5
Minimum scan time/line:20 ms.
st=6
Minimum scan time/line:40 ms (normal);
20ms (fine).
st=7
Minimum scan time/line:40 ms.
+FDCS=vr,br,wd,ln,
df,ec,bf,st
Current session parameter; refer to +FDCC
command.
+FDIS=vr,br,wd,ln,
df,ec,bf,st
Current session negotiation parameter; refer
to +FDCC command.