Yamaha WH39070 - Manual (Page 99)

99
9
Input/output patching
Changing the input patching
LS9-16/32 Owner’s Manual
When the LS9 is in the initial state, the following input ports (jacks / internal ports) are patched to
each input channel.
However, the above patching can be modified as needed.
Here’s how to change the patching of each input channel.
1
Press the [HOME] key to access the
SELECTED CH VIEW screen, and use the
[SEL] keys to select an input channel.
1 Channel number / Channel name
B HA popup button
C Port select popup button
2
Move the cursor to the HA popup button in
the screen, and press the [ENTER] key.
The HA/PATCH popup window will appear. In this
popup window, you can view the input port and name
selected for each input channel, turn the phantom
power on/off, adjust the gain, and switch between nor-
mal/reversed phase, in groups of eight channels.
1 Channel number
This is the number of the input channel.
B Channel name
This is the name of the input channel.
C Port select popup button
This button selects the input port assigned to the chan-
nel. The currently selected input port is shown.
D +48V button
This button switches the phantom power on (red) or
off (black) for the head amp assigned to that channel.
E GAIN knob
This indicates the amount of gain for the head amp
assigned to that channel. Move the cursor to the knob
and use the dial or the [DEC]/[INC] keys to adjust the
setting. The level meter located immediately to the
right of the knob shows the input level of the corre-
sponding port.
F ø (phase) button
This button switches the head amp assigned to that
channel between normal phase (black) and reverse
phase (orange).
Changing the input patching
For the LS9-16
Input channels Input port (jack / internal port)
INPUT channels 1–16 INPUT jacks 1–16
INPUT channels 17–32 Slot input channels 1–16
ST IN channels 1–4 (L/R) Rack outputs 5–8 (L/R)
For the LS9-32
Input channels Input port (jack / internal port)
INPUT channels 1–32 INPUT jacks 1–32
INPUT channels 33–48 Slot 1 input channels 1–16
INPUT channels 49–64 Slot 2 input channels 1–16
ST IN channels 1–4 (L/R) Rack outputs 5–8 (L/R)
1 2 3
• As an alternative to using the HA popup button, you can also
select the input port in the PATCH/NAME popup window that
appears when you move the cursor to the port select popup
button and press the [ENTER] key (
→ p. 55).
HINT
1
2
3
4
5
6
• The PAD will be internally switched on or off when the HA
gain is adjusted between -14 dB and -13 dB. Keep in mind
that noise may be generated if there is a difference between
the Hot and Cold output impedance of the external device
connected to the INPUT connector when using phantom
power.
NOTE