Yamaha WH39070 - Manual (Page 64)

64
Sending the signal from an input channel to a MIX bus
LS9-16/32 Owner’s Manual
In this method, you use the MIX SEND popup window to
adjust the send levels from eight channels to a MIX bus.
1
Make sure that an output port is assigned
to the MIX bus to which you’re sending the
signal, and that a monitor system or exter-
nal effect processor etc. is connected to the
corresponding output port.
2
Press the SELECTED CHANNEL section
[HOME] key.
The SELECTED CH VIEW screen will appear in the
display.
1 SEND popup button
3
Use the LAYER section keys and the [SEL]
keys of the channel module section or ST
IN section to select the send-source input
channel.
4
Use the MIX/MATRIX SELECT section keys
to select the send-destination MIX bus.
5
Move the cursor to the SEND popup button
in the screen, and press the [ENTER] key to
access the MIX SEND popup window.
In the MIX SEND popup window you can control the
send level, on/off setting, and send point for the sig-
nals sent from a set of eight input channels to the cur-
rently selected MIX bus.
The MIX SEND popup window shows the parameters
for the eight channels that include the channel you
selected in step 3. The contents of the window will dif-
fer depending on whether the send-destination MIX
bus is VARI type or FIXED type.
[ For a VARI type MIX bus ]
1 Channel number / Channel name
This indicates the number and name of the send-
source channel.
B PRE button
This switches the position from which the signal is
sent from the send-source channel to the currently
selected MIX bus. If this button is on, the pre-EQ or
pre-fader signal will be sent; if this button is off, the
signal from immediately after the [ON] key will be
sent.
C TO MIX ON/OFF button
This is an on/off switch for the signal that is sent from
the send-source channel to the currently selected MIX
bus.
D TO MIX LEVEL knob
This adjusts the level of the signal that is sent from the
send-source channel to the currently selected MIX
bus.
E ALL PRE button
This button selects PRE as the position from which the
signals are sent from all input channels to the VARI
type MIX bus.
F ALL POST button
This button selects POST as the position from which
the signals are sent from all input channels to the
VARI type MIX bus.
If the send-destination MIX bus is set to stereo, the
screen will change as follows.
Using a popup window
1
• If you’ve turned on POPUP APPEARS WHEN PRESSING
KNOBS in the PREFERENCE popup window ( → p. 194), you
can also access the above popup window by pressing the
SELECTED CHANNEL section [SELECTED SEND] encoder.
• If you want to switch the on/off status of the signal sent to a
VARI type MIX bus, you can move the cursor to the TO MIX
LEVEL knob in the screen and press the [ENTER] key to
access the above popup window.
HINT
3
4
2
1
5 6
7