Yamaha WH39070 User Manual
Page 51
51
Setup required when starting up
LS9-16/32 Owner’s Manual
4
Connections and setup
6
Raise the fader of the currently selected
channel (or the encoder for a ST IN chan-
nel) to obtain an appropriate volume.
In this state, you should hear sound from the speaker
system patched to the STEREO channel. If you don’t
hear sound, watch the stereo meter located at the right
of the display to see whether the LR meter is moving.
●
If the LR meter is moving
It is possible that the output jack connected to your
speaker system is not correctly patched to the STE-
REO channel. Check the output port patching (
●
If the LR meter is not moving
It is possible that the channel’s [ON] key is off, or that
the ST button is turned off in the SELECTED CH
VIEW screen. Check the setting of the [ON] key or ST
button.
7
To adjust the pan/balance of the signal that
is sent from the input channel to the STE-
REO bus, turn the SELECTED CHANNEL
section [PAN] encoder.
When you turn the [PAN] encoder, the PAN/BAL
knob in the SELECTED CH VIEW screen will also
move in tandem with it. You can obtain the same result
by moving the cursor to the PAN/BAL knob and oper-
ating the dial or the [DEC]/[INC] keys.
8
To control another channel, use the [SEL]
keys to select another channel and make
settings in the same way.
● Controlling the signal sent to the STE-
REO bus, eight channels at a time
Here’s how to access a popup window in which the level
and pan/balance of the signal sent to the STEREO bus can
be adjusted for eight channels at a time.
1
Press the SELECTED CHANNEL section
[HOME] key.
The SELECTED CH VIEW screen will appear in the
display.
1
PAN popup button
B
PAN/BAL knob
2
Use the keys of the LAYER section and the
[SEL] keys of the channel module section
to select the channel for the INPUT jack you
want to control.
3
Move the cursor to the PAN popup button
or PAN/BAL knob in the SELECTED CH
VIEW screen, and press the [ENTER] key.
The TO STEREO/MONO popup window will appear,
allowing you to adjust the level and pan/balance of the
signal sent to the STEREO bus, eight channels at a
time. This popup window shows the parameters for the
eight channels that include the channel you selected in
step 2.
1
ST button
B
PAN/BAL knob
• You can also use headphones connected to the front panel
PHONES OUT jack to monitor the signal that is being output
from the STEREO channel (
HINT
2
1
1
2