Yamaha WH39070 - Manual (Page 183)

183
Using control changes to control parameters
LS9-16/32 Owner’s Manual
18
MIDI
You can use MIDI control change messages to control specified events (fader/encoder opera-
tions, [ON] key on/off operations etc.) on the LS9. This capability can be used to record fader and
key operations on a MIDI sequencer or other external device, and play back this data later.
You can use control changes to control events in either of the following two ways.
● Using control changes
This method uses typical control changes (control numbers 1–31, 33–95, 102–119). You can freely assign an
event to each control number.
● Using NRPN (Non Registered Parameter Number)
This method uses a special type of control change messages called NRPN.
NRPN uses control change numbers 62 and 63 to specify the MSB (Most Significant Byte) and LSB (Least Sig-
nificant Byte) of the parameter number, and subsequently-transmitted control change messages of control
change number 6 (or 6 and 26) to specify the value of that parameter.
The event assigned to each combination of MSB and LSB is pre-defined, and cannot be changed.
1
Connect the LS9 to your external device.
2
In the DISPLAY ACCESS section, press the
[SETUP] key repeatedly to access the MISC
SETUP screen.
3
Move the cursor to the MIDI SETUP popup
button, and press the [ENTER] key to
access the MIDI SETUP popup window.
4
As described in “Basic MIDI settings” (
→
p. 178), select the ports and MIDI channels
that will be used to transmit/receive control
changes.
5
When you’ve finished making settings,
move the cursor to the CLOSE button and
press the [ENTER] key to close the popup
window.
You will return to the MISC SETUP screen.
6
Move the cursor to the CONTROL CHANGE
popup button, and press the [ENTER] key
to access the CONTROL CHANGE popup
window.
In the CONTROL CHANGE popup window you can
specify how control changes will be transmitted and
received, and assign the event (fader/encoder opera-
tion, [ON] key on/off operation, etc.) assigned to each
control number. This page includes the following
items.
1 CONTROL CHANGE field
Here you can switch control change transmission/
reception on/off, and specify whether control changes
will be echoed out. This setting is linked with the
CONTROL CHANGE field of the MIDI SETUP
popup window.
Using control changes to control parameters
• For details on the events assigned to NRPN messages, refer to the appendix ( → p. 253).
HINT
1
4
5
3
2