Xerox XES 8855 - Manual (Page 38)

32
CARE
Replacing the Oil Pads
Three oil pads, which apply
silicone oil to the surface of
the fuser roll, are located
under the fuser cover. The oil
pads are packed as part of the
toner and supplies kit, which
also contains eight toner
cartridges and four toner
waste containers.
The oil pads should be
replaced at the same time that
the first of the eight toner
cartridges is used in the
printer.
WARNING
Switch the printer off and
allow the fuser to cool for 15
minutes before replacing the
oil pads.
Avoid contact with face or
eyes and wipe/wash your
hands thoroughly after
handling.
1. Open the fuser cover.
2. Replace the three oil pads
as shown.