Xerox XES 8855 - Manual (Page 21)

15
Manual Bypass
MANUAL BYPASS FEED
The bypass feed mode is used
when the print, which is being
sent to the printer, is a
different size than the roll
media loaded in the printer.
For example:
You want to send a C size
print, but there is no C size
media loaded in the printer.
You can use the bypass feed
mode to run the C size print,
using cut sheet media.
When the correct media is not
loaded for an incoming print,
the Status Display shows the
flashing code P-05.
1. Adjust the paper guides to
the correct size.
2. Feed the cut sheet media
squarely into the printer,
curl side down and
between the guides, until
the media stops.
•
The Status Display
indicates the size when the
media is loaded (05-xx).