Wacom Intuos2 XD-0608-R - Manual (Page 137)

APPENDICES
Page 137
Contents
Index
1. From the D RAWING E DITOR , open the T OOLS menu (O PTIONS menu for Release 13).
2. Select T ABLET , and then C ONFIGURE .
3. Define tablet menu areas. Follow the prompts at the bottom of the A UTO CAD D RAWING E DITOR .
Type the number of tablet menu areas you want (0-4) and press E NTER . If you do not want to use a
menu template, type 0 (zero). Digitize the upper-left, lower-left, and lower-right corners of the menu
area and then press E
NTER . Next, enter the number of columns and press E NTER . Now enter the
number of rows and press E NTER . Repeat for each menu area.
4. Define the fixed screen pointing area. By default, the entire tablet is a fixed screen pointing area.
If you are using a menu template, you should re-specify the fixed screen pointing area to match the
template. Continue to follow the prompts at the bottom of the A
UTO CAD D RAWING E DITOR screen.
5. Define the floating screen pointing area—it allows you to access all areas of the screen. The floating
screen pointing area takes precedence over T ABLET M ODE O N , the fixed screen pointing area, and the
menu areas. Continue to follow the prompts at the bottom of the A UTO CAD D RAWING E DITOR screen.
Please check your AutoCAD documentation for additional information.