Wayne-Dalton Z-Wave WDUSB-10 - Manual (Page 15)

Locking/Unlocking ThinkEssentials
®
15
LoCkeD/UNLoCkeD link is located in lower
left hand corner of Thinkessentials
®
window.
Use the following procedure to lock/unlock
ThinkEssentials
®.
Thinkessentials
®
software operates in two
modes: a) locked and, b) unlocked. Unlocked
mode is generally used for setup and con-
figuration of the network. Most users run
Thinkessentials
®
in locked mode for day-to-day
use, and unlock the software to make con-
figuration changes. To toggle between these
two modes, simply click on the lock icon in the
corner of the software interface or its accompa-
nying text.
In LoCkeD mode the software:
• Does not allow changes to modules, devices,
layout, scenes, zones, or other settings.
• Prevents the adding or removing of modules
in the network.
• Does allow general control, such as turning
modules on or off or activating scenes.
• Gives quick access to dimming or other regu-
larly used controls by right-clicking on modules.
In UNLoCkeD mode the software:
• Allows creation and modification of Designs,
Scenes, Zones and Settings.
• Allows user more options such as renam-
ing or configuring devices by right-clicking on
modules.
NoTe: Some options, such as ADD DeVICe and
ReMoVe DeVICe may still be unavailable when
the software is unlocked if your USB
Z-Wave
®
adapter is a secondary controller in
the network. only Primary Controllers can add
or remove modules to or from a network.
Common Operations
