Welch Allyn SCANTEAM 3400PDF - Manual (Page 87)

SCANTEAM 3400PDF User’s Guide
Disable
Record
The following chart lists the factory default Serial Interface Menu settings
(indicated by a ✱" on the programming menu pages).
Parameter Name
Page
Reference
Default Setting
Prefix / Suffix Selections
Beeper Volume High Page 2-8
Output Selections
Code I.D. Transmit Disable Page 2-11
AIM I.D. Transmit Disable Page 2-11
Serial Communication Selections
CTS Check Disable Page 2-12
RSĆ232 Word Length 7 Data Bits, 1 Stop Bit Page 2-13
Baud Rate 9600 Page 2-12
Parity Even Page 2-14
Primary Prefix None Page 2-4
Primary Suffix None Page 2-4
Function Code Transmit
Scan Voting
Intercharacter Delay
Enable
Disable
00 (x5mS)
Page 2-11
Page 2-11
Page 2-9
Output Delays
Interfunction Delay 00 (x5mS) Page 2-9
Intermessage Delay 00 (x5mS) Page 2-9
Reread Delay Low (175mS) Page 2-10
Good Read Delay None Page 2-10
Protocol Page 2-14
Data Formatter Selections
Serial Interface Menu Defaults
Require Data Format Page 2-17
Ticking/Scanning Progress Enable Page 2-8
Humming/Busy Decoder Enable Page 2-8
AutoTrigger Disable Page 2-10
Section98 Default Charts