Welch Allyn SCANTEAM 3400PDF - Manual (Page 44)

3–4 SCANTEAM 3400PDF User’s Guide
Wake Up Pulse Selection
10 ✱ 25
Transmission Rate Selection
40 80
120 150
200 300
Enable ✱ Disable
This programming selection sets the transmission rate from 10 ips (inches per
second) to 300 ips if the scanner is in Wand Emulation mode. Programming the
transmission rate causes the data to be sent at the specified rate. The
programmed transmission rate must be compatible with the device receiving
the bar code data. Default = 25 ips (inches per second).
This selection provides a wake up" pulse on the sync line from the scanner to
a portable terminal. This feature extends battery life of the portable terminal by
waking up the terminal only when data is ready to be sent. Bar code data follows
the wake up pulse after a 0.2 second delay. Default = Disable.