Watlow MINICHEF 2000 Griddle Applications - Manual (Page 38)

A p p l i c a t i o n 2 3 Wa t l o w M I N I C H E F 2 0 0 0 ■ 3 7
3. Press the Cook Time key again.
The cooking time has been set.
[`idle] will appear on the display.
Five Second Timeout
When using the up or down keys to change a value, if you do not press any key for 5
seconds, the controller will automatically be set to the last value on the display and
return to [`idle].
Preheat
If the [Ready] parameter under the [SetUp] function in the Configuration mode is set
to [``yes], the controller will detect temperatures and preheat to operating tempera-
ture (above set point minus the ready band).
Note: The controller will not respond if Time1 is set to 0.
The menu you have chosen becomes the current menu for controller operation. Until
the menu is completed or canceled , the indicator light above the Start/Stop key will
light up (flashing or steady).
• If the griddle is not at operating temperature, it will preheat. Meanwhile:
The word [Pre-`] [`Heat] will appear on the display for a few moments.
The menu key indicator light will flash slowly.
The temperature of Channel 1 will be displayed until the operating temperature for
both channels is reached.
The heat output indicator light (G, just below the display) will light up whenever
the controller is calling for heat.
When the channel is at operating temperature (set points minus the ready band)
[ready] will appear on the display and the Start/Stop key indicator light will flash
rapidly. You are now ready to cook.
• If the griddle is at operating temperature, the display goes directly to [Ready]
without indicating preheat or temperature.
Run a Menu (with preheat feature)
This procedure describes how to run the menu when the preheat feature is active (when
the [Ready] parameter in the [SetUp] function of the Configuration Mode is set to
[```Yes]).
1. Set the menu as shown earlier.
2. With [`idle] or time of day on the display, press the Start/Stop key.
If the preheat condition (temperatures >= set point minus the ready band) has not
been met, the griddle will preheat until [ready] appears on the display.
If the griddle is at operating temperature [ready] will appear on the display.
A B
D E
C
F
G H
M INI C HEF 2000
[`idle]
Edit Accept
Back-Up Exit
SLOW
FLASH
AT OPERATING TEMPERATURE
(PREHEAT CONDITION MET)
RAPID
FLASH
B
D E
C
F
M INI C HEF 2000
[100f`]
Edit Accept
Back-Up Exit
B
D E
C
F
M INI C HEF 2000
[ready]
Edit Accept
Back-Up Exit
G H G H
A A
[pre-`] [`Heat]