Watlow MINICHEF 2000 Griddle Applications - Manual (Page 15)

1 4 ■ Wa t l o w M I N I C H E F 2 0 0 0 A p p l i c a t i o n 2 1
Auto-tuning Note:
Before auto-tuning Application 21 for zone 1, [TeNp1] must first be set to a value that
is typical for zone 1. (See the Hardware & Software Setup Guide for information on pro-
gramming menus.) Then set [tHErL] / [tunE1] to [```on]. After you accept [```on],
by pressing “Enter,” the controller will display [`tunE] while auto-tuning is taking
place.
Then you can auto-tune zone 2, by first setting [TeNp1] of Menu 1 to a value that is
typical for zone 2. Then set [tHErL] / [tunE2] to [```on]. After you accept [```on],
by pressing “Enter,” the controller will display [`tunE] while auto-tuning is taking
place.
The controller will cancel the auto-tuning process if it cannot be completed in 80 min-
utes. You can cancel the auto-tuning process at any time by pressing either key C or key
D and accepting [``Off], by pressing “Enter,” when it appears.