Warning – Wayne-Dalton 8800 User Manual

Page 23

Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your

local yellow pages/business listings or go to the

Find a Dealer section online at www.wayne-dalton.com

Tools Needed:

iNST

alla

Tio

To adjust spring tension, fully close door. Apply

locking pliers to track above third roller. Insert

a winding bar into the winding cone. Push

upward on the winding bar while carefully

loosening the set screws in the winding cone.

BE PREPARED TO SUPPORT ThE

FULL FORCE OF ThE TORSION

SPRING ONCE ThE SET SCREWS

ARE LOOSE.

Carefully adjust spring tension 1/4 turn.

Retighten both set screws in the winding cone

and repeat for the other side. Recheck door

balance DO NOT ADjUST MORE ThAN 1/2

TURN FROM ThE RECOMMENDED NUMBER OF

TURNS. If door still does not balance correctly,

contact a qualified door agency.

If the door still does not operate easily, lower

the door into the closed position, UNWIND

ThE SPRING(S) FULLY (Refer to “P1” on page

5 “Removing an old door”) and recheck the

following items:

1.) Check the door for level.

2.) Check the torsion tube for level.

3.) Check the track spacing.

4.) Check the counterbalance cables for

equal tension.

5.) Check the track for potential

obstruction of the rollers.

6.) Clamp locking pliers onto track and

rewind springs.

imPoRTaNT: IF DOOR STILL DOES NOT

OPERATE PROPERLY, ThEN CONTACT A

qUALIFIED DOOR AGENCY.

Rear Support continued...

PERFORATED ANGLE

(3) 5/16” BOLTS

& NUTS

hORIzONTAL TRACK

BOLT MUST ExTEND INTO

ThE TRACK TO SERVE AS

A ROLLER STOP

PERFORATED

ANGLE BRACE

PERFORATED ANGLE -BOLTED

USING (2) 5/16” x 1-5/8”

hEx hEAD LAG SCREWS

TO CEILING MEMBER AND

PARALLEL TO WIDTh OF DOOR

SOUND FRAMING MEMBERS

hORIzONTAL TRACK

BOLT MUST ExTEND INTO

ThE TRACK TO SERVE AS

A ROLLER STOP

jAMB

WEAThER

SEAL

PERMANENTLY ATTAChED

WEAThER SEAL